Issue flashing Atmega2560 using Raspberry Pi (linuxgpio). File size is 152kb.

classic Classic list List threaded Threaded
1 message Options
Reply | Threaded
Open this post in threaded view
|  
Report Content as Inappropriate

Issue flashing Atmega2560 using Raspberry Pi (linuxgpio). File size is 152kb.

Mike Brandon
Hello,

I receive a verification error when avrdude is verifying the flash of a
file I am sending to an Atmega2560. I can use AVR Studio to flash the same
chip with the same file and it is successful. I can also flash the chip
with avrdude when the file size is smaller ( I haven't tested too many
different files but I wanted to point out that my raspberry pi setup has
been successful with this same chip using avrdude).

Below is the output when using avrdude:


If I try and verify the flash with AVR Studio I receive the following:



Any advice or pointers to a solution would be greatly appreciated.

Thank you,

Mike Brandon


_______________________________________________
avrdude-dev mailing list
[hidden email]
https://lists.nongnu.org/mailman/listinfo/avrdude-dev

avrdude-write-read.PNG (130K) Download Attachment
verify-using-avr-studio.PNG (63K) Download Attachment
Loading...